Respironics 920M Manual del operador descargar pdf (Pagina 6)

As with all medical equipment, carefully route patient cabling to

reduce the possibility of patient entanglement or strangulation.

This device should not be used adjacent to or stacked with other

equipment. If adjacent or stacked use is necessary, the device

should be observed carefully to verify normal operation.

The use of accessories, sensors, and cables other than those

specified may result in increased emission and/or decreased

immunity of this device.

This device is a precision electronic instrument and must be repaired

by qualified technical professionals. Field repair of the device is not

possible. Do not attempt to open the case or repair the electronics.

Opening the case may damage the device and void the warranty.

This device must be able to measure the pulse properly to obtain an

accurate SpO

measurement. Verify that nothing is hindering the

pulse measurement before relying on the SpO

measurement.

Operation of this device below the minimum amplitude of 0.3%

modulation may cause inaccurate results.

Discontinue use of adhesive tape strips if the patient exhibits an

allergic reaction to the adhesive material.

Do not stretch the adhesive tape while applying the pulse oximeter

sensor. This may cause inaccurate readings or skin blisters.

The device turns off after approximately 10 minutes when at critically

low battery capacity.

.Cautions

Before use, carefully read the Instructions for Use provided with the

sensors.

Inspect the sensor application site at least every 6 to 8 hours to

ensure correct sensor alignment and skin integrity. Patient sensitivity

to sensors and/or double-backed adhesive strips may vary due to

medical status or skin condition.

Warnings (Continued)

1 2 3 4 5 6 7 8 9 10 11 ... 88 89

Sin comentarios

Respironics 920M Manual del operador Pagina 6